Quick answer: On a Samsung Washer, the bE error code (also displayed as 6E, bE2, or bE3 on some models) means the machine has detected a button or control panel key that appears to be stuck or pressed continuously. Samsung Washer bE typically occurs because a button is physically jammed, a control panel membrane is damaged, or moisture has entered the control panel circuitry. Start by checking for a physically stuck button and drying the control panel before investigating internal components.
The Samsung Washer bE error code means the control board is detecting a continuous signal from one or more buttons on the control panel. Each button on the Samsung Washer is connected to the control board through the touch membrane or switch assembly. When a button is pressed, it sends a brief electrical signal. If the control board detects a continuous signal from a button — as if it is held down permanently — it stops the machine and displays bE because it cannot distinguish intended input from a hardware fault.
A button that has become physically jammed in the pressed position — from detergent residue, a dropped object, or mechanical damage — sends a constant signal and triggers Samsung Washer bE. This is the most straightforward cause and often the easiest to fix.
Water splashing onto the Samsung Washer control panel, cleaning with a wet cloth, or steam from nearby sources can create conductive paths between button contacts on the membrane. This mimics a pressed button and causes bE.
The printed membrane beneath the control panel buttons can develop cracks, delamination, or conductive wear spots over years of use. A membrane defect can create a permanent connection on one or more button circuits, continuously triggering Samsung Washer bE.
In rare cases, the control board’s button input circuitry may develop an internal fault that reads a button as permanently pressed. If the membrane and buttons are confirmed to be in good condition, board failure may be the cause of Samsung Washer bE.
Follow the steps below one at a time — many error codes can be fixed faster than they look.
Unplug the Samsung Washer for 5 minutes. Inspect the control panel carefully. Press each button individually and feel for one that does not spring back cleanly. Attempt to free any stuck button gently with your fingernail — do not use metal tools that could damage the panel surface.
Use a dry, lint-free cloth to wipe the entire control panel surface. Pay close attention to the gaps around each button. If moisture has entered the panel, leave the Samsung Washer unplugged in a warm, dry environment for several hours before retesting. Do not use a hair dryer on high heat near the control panel.
Plug the Samsung Washer back in and power on. If bE appears immediately without pressing anything, one button is still registering as continuously held. Press each button in sequence while watching the display — note which one causes bE to appear or intensify. This identifies the affected button.
If a specific button is identified as stuck or defective and cannot be freed physically, the control panel assembly (including the membrane) will need replacement. Samsung Washer control panels are available as complete assemblies for most models and can be replaced by removing the front panel and unplugging the ribbon connector.
If the control panel has been replaced or confirmed to be in perfect condition but Samsung Washer bE still appears, have the main control board evaluated. An internal input fault on the board will require professional diagnosis and board replacement.
Yes. Cleaning the Samsung Washer control panel with a wet cloth or spray cleaner while the machine is on can cause bE if moisture reaches the button membrane. Always wipe with a damp (not wet) cloth and with the machine powered off.
Yes. Samsung Washer bE and 6E are the same button error code displayed differently depending on model generation. The cause and repair are identical.
Samsung Washer bE is a button error caused by a continuously pressed control panel key. Check for physically stuck buttons, dry the control panel thoroughly, and power-reset the machine. If a specific button is confirmed defective, replace the control panel membrane assembly. Persistent bE after panel replacement points to a control board fault requiring professional service.
See all Samsung Washer error codes: Samsung Washer Error Codes – Complete Guide
Try these recommended tools — used by thousands to solve the same issue:
As an Amazon Associate / affiliate partner we may earn from qualifying purchases.
Browse More Fixes